Previously, we remove LOGO and other unnecessary image information by adding a video effect to an image. Now, you may do the job when capturing the clip.

1. Click the Video Dynamic Adjust button in the Input Info tab of the VA Capture window, and the VA Capture Setup window pops up, as shown below. You may set four different areas for processing at most;

2. First, choose the position of LOGO. For example, if the LOGO is located in the lower right corner of the image, you may click the rectangular box in the lower right corner of the Edit window, and the box turns green, indicating it’s selected. Accordingly, the MaskAdjust section on the right side shows Rect Mask3 is selected. You may also drag the edges of the box to change the size and position of the area to be adjusted;

3. Next, set the effect of processing. Check the FxRect Valid option on the right side, and select Blur or Mosaic effect from the pulldown menu, and then make satisfactory masking by adjusting the X and Y parameters. (You may view the changes in the Capture Playback Window when making the adjustments)

4. When you are done with the settings, click the Exit button to close the window.

After this setting, the LOGO in the image of the captured clip is automatically masked.